Bosch FPD-7024 - ALT. Comm; Prog Formats; 4;2 Zone Report

FPD-7024 | Operation and Installation Guide | 5.0 Control Panel Programming
.
Bosch Security Systems, Inc. | 1/10 | F01U008458-03 67
5.6.7 ALT. Comm
Shortcut: 0-PROG, 6-PROG ACC’NTS, 7-ALTER COMM
This prompt is used with the DX4020 or DX4010.
If using the DX4020 select 0 network and if using the DX4010 select 1-serial.
The following window appears:
ALTER COMM (_)
0 – NETWORK
1 - SERIAL
5.7 PROG FORMATS
PROG FORMATS
1 - 4/2 ZONE REPT
2 - 4/2 RPT CODS
3 - BFSK RPT CDS
This feature offers the use of hexadecimal digits (0 through F). Because the specific keys A through F
are not available on the keypad, use the equivalent keys listed below.
History: A
Test: B
Disable: C
Drill: D
Silence: E
Reset: F
5.7.1 4/2 Zone Report
Shortcut: 0-PROG, 7-PROG FORMATS, 1-4/2 ZONE RPTS
4/2 Zone reports consist of an event type (first digit) and a point number (second digit). These reports apply
only to points, and only when a 3/1 or 4/2 format is selected.
The following window appears:
4/2 ZONE RPT
0- FIRE ALRM D1
1- FIRE RSTR D1
2- WATERFLOW D1
3- SUPERVISE D1
4- TROUBLE D1
5- TRBL RSTR D1
6- DISABLE D1
7- DSBL RSTR D1
8- (RESERVED)
9- MORE
Press the number key that corresponds with your selection of event type (D1 stands for digit 1). Press
[#/Enter].