Bosch FPD-7024 - Program Menu Tree

FPD-7024 | Operation and Installation Guide | 1.0 Overview
.
Bosch Security Systems, Inc. | 1/10 | F01U008458-03 9
Table 2: LED Assignments for LED Annunciators 4 and 8
D7030X Zones
Covered
Shown on
7030X
Shown on
D7032 (if
attached)
COMMENTS
1 1 to 16 1 to 8 9 to 16 Combination with lowest option bus address (such as Address 1)
2 17 to 32 17 to 24 25 to 32 Combination with second lowest option bus address (such as
Address 2)
3 33 to 48 33 to 40 41 to 48 Combination with third lowest option bus address (such as
Address 3)
4 49 to 64 49 to 56 57 to 64 Combination with fourth lowest option bus address (such as
Address 4)
5 1 to 16 1 to 8 9 to 16 Fifth combination repeats first combination
6 17 to 32 17 to 24 25 to 32 Sixth combination repeats second combination
7 33 to 48 33 to 40 41 to 48 Seventh combination repeats third combination
8 49 to 64 49 to 56 57 to 64 Eighth combination repeats forth combination
Refer to Table 3 for the LED display for Zones 49 to 64.
Table 3: LED Display for Zone 49 to 64
LED Zone Description
1 49 User defined
2 50 User defined
3 (reserved)
4 52 General fire alarm monitor waterflow (non-silencable)
5 53 General fire alarm monitor (silencable)
6 (reserved)
7 55 General Supervisory (silencable)
8 56 General Waterflow (silencable)
9 (reserved)
10 58 General supervisory alarm (non-silencable)
11 (reserved)
12 (reserved)
13 61 General waterflow alarm (non-silencable)
14 (reserved)
15 63 General alarm monitor waterflow (non-silencable)
16 (reserved)
1.2.7 Communicator
The communicator can report to two phone
numbers or IP addresses with full single, double,
and back-up reporting. Communicates in SIA,
Modem IIIa2, Contact ID, BFSK, and 3/1 and 4/2
Tone burst formats.
The communicator must be enabled
and configured to operate. The
communicator and phone line monitors
are disabled in the default factory
configuration.