FPD-7024 | Operation and Installation Guide | 5.0 Control Panel Programming
58
Bosch Security Systems, Inc. | 1/10 | F01U008458-03
5.6 PROG ACCOUNTS
PROG ACC’NTS
1- PHONE / IP NUMS
2- PHON CONTROL
3- RPT STEERING
4- RING COUNT
5- COMM. TRIES
6- MACH. BYPASS
7- ALT.COMM
SERIAL/NETWORK
5.6.1 Phone Numbers/IP Addresses
Shortcut: 0-PROG, 6-PROG ACC’NTS, 1-PHONE/IP NUMS
The system can be programmed with two reporting phone numbers or IP addresses. Phone/IP #1 is used
with Account Number 1; Phone/IP #2 is used with Account Number 2. Remote programming occurs on Line 1
using Phone/IP #3.
PHONE/IP #1: Phone Number 1 or IP address 1
PHONE/IP #2: Phone Number 2 or IP address 2
COMPTR PHONE: Sets the Phone Number or IP Address to call for remote programming.
Refer to Table 15 on page 32.
The following window appears:
PHONE /IP NUMBER
1- PHONE /IP #1
2- PHONE /IP #2
3- COMPTR PH/IP
Press the number key that corresponds with the phone number you wish to configure (example is Phone #1).
The following window appears:
PHONE /IP NUMBER #1
1- NUMBER
2- PORT NUMBER
3- FORMAT
4- ACCT NUMS
5- TONE
Press the number key that corresponds with your selection. Refer to the next four sub-sections (Number,
Format, Account Numbers and Tone) for explanations of the phone number options.
Number
The display scrolls through the Phone /IP Number options. Press [1] for NUMBER. The following window
appears:
PHONE /IP NMBR 1: >????
????????????????
Press [1]. Press [TEST][4] to add the wait for dial tone, and then enter the phone number and press [#/Enter].
The previous menu appears. You can include several other special control characters in the phone number
by pressing [Test] followed by a digit (Table 22).
To Next Page
Loading...
