Bosch FPD-7024 - Auto Program; Figure 13: D7039 Mounting Location

FPD-7024 | Operation and Installation Guide | 5.0 Control Panel Programming
74
Bosch Security Systems, Inc. | 1/10 | F01U008458-03
Figure 13: D7039 Mounting Location
21 3
4 5 6
7 8 9
#
Cmnd
0
Prog
*
Clear
Disable
Drill
Test
Histor y
Reset
Silence
Trouble
Silenced
Power
Alarm
1
2
3
4
6
7
8
9
10
5
5
1 - D7039 MUX Expansion module
2 - Enclosure
3 - FPD 7024 Control board
4 - I/O module for the D7039 MUX Expansion
module
5 - I/O module for the D7039 MUX Expansion
module
6 - Addresses 9 to 128
7 - MUX Class A
8 - Addresses 129 - 255
9 - Addresses 9 to 128
10 - MUX Class B
5.9.4 Auto Program
Shortcut: 0-PROG, 9-PROGRAM MUX 4- AUTO PROGRAM
This option provides a convenient way for the installer to configure the FPD-7024 to operate with the existing
devices on the multiplex buses by scanning the buses for missing or new multiplex devices.
The following display appears:
AUTO PROGRAM?
_____:YES(1)/NO(0)
Press [1] to continue with auto programming or [0/Prog] to cancel. When you press [1], the FPD-7024 checks
for existing programming errors in which devices are programmed incorrectly in the space required for a
lower-addressed multi-point device (such as a dual point module). If a point is found to be programmed under
another device, the following error message appears for five seconds, and the auto programming process
aborts:
ADDRESS ERROR 1
AT ADDRESS xxx