Bosch FPD-7024 - Report Steering

FPD-7024 | Operation and Installation Guide | 5.0 Control Panel Programming
.
Bosch Security Systems, Inc. | 1/10 | F01U008458-03 65
5.6.3 Report Steering
Shortcut: 0-PROG, 6-PROG ACC’NTS, 3-RPT STEERING
Different classes of reports can be directed to different phone numbers. Non-supervisory alarms include fire
alarms and waterflow alarms. Supervisory alarms come from points configured as a supervisory type. Non-
supervisory restorals include fire and waterflow restorals. Supervisory restorals come only from points
configured as a supervisory type. Trouble reports include all point and system troubles and restorals. Tests
include Auto Tests, Manual Tests and Off-normal at Test Reports. The control panel allows the special
reports Silence, Reset, and Drill to be individually directed.
If any reports are directed to Phone/IP Number 2 (including the default, PHONE 2 BACKUP), a
phone number and account number must be programmed for Phone/IP Number 2. The control
panel indicates a COMM FAULT if it sends a report (using Phone Number 1 parameters) which
references unprogrammed Phone/IP Number 2 parameters.
The display scrolls through the following items:
REPORT STEERING
1- NONSUP ALRM
2- SUPVSY ALRM
3- NONSUP RSTR
4- SUPVSY RSTR
5- TROUBLE
6- TESTS
7- SILENCE
8- RESET
9- DRILL
Press the number key that corresponds to your selection. Selecting, for example NON-SUPERVISORY
ALARM produces the following window:
NONSUP ALRM (___)
1- PHONE/IP 1 ONLY
2- PHONE/IP 2 ONLY
3- PHON/IP 1 AND 2
4- PHN/IP 2 BACKUP
5- NO REPORT
PHONE/IP 1 ONLY: Report sent to Phone/IP 1 only.
PHONE/IP 2 ONLY: Report sent to Phone/IP 2 only.
PHONE/IP 1 AND 2: Report sent to Phone/IP Numbers 1 and 2.
PHONE/IP 2 BACKUP: Report sent to Phone/IP 1, then to Phone/IP 2 if 1 fails.
NO REPORT: No report sent.
Press the number key that corresponds with your selection. The previous window appears.