Bosch FPT-DACT - Page 3

EN | 3FPT-DACT | Operation & Installation Guide |
1/05 | F01U002505B
Contents
Tables
Table 1: Power Specifications ......................................... 5
Table 2: Input Point Specifications ................................ 6
Table 3: General Specifications ..................................... 7
Table 4: Parts List ............................................................... 7
Table 5: Report Routing with Primary and Alternate
Phone Number, Phone 2 Backup ................. 19
Table 6: Input Point Voltage Levels ..............................22
Table 7: System Fault (Fault or Open)
Voltage Levels....................................................23
Table 8: Event History Abbreviations ...........................27
Table 9: Sys Trouble LED Indications..........................45
Table 10: 4/2 Reporting Codes ....................................... 47
Table 11: Reporting Summaries ......................................48
Table 12: Equipment Fail Conditions .............................50
Table 13: Point-Related Report Routing .......................55
Table 14: Non-Point Related Report Routing ..............55
Table 15: DCT-1/-1E UL Listed Compatibility .............56
Figures
Figure 1: FPT-DACT PCB Layout .................................. 8
Figure 2: Wire Knockout Locations ...............................9
Figure 3: Mounting FPT-DACT Case to Wall
(Inside View)....................................................... 9
Figure 4: Light Pipe ......................................................... 10
Figure 5: Mounting the FPT-DACT Board ................. 10
Figure 6: Conduit Connections ................................... 11
Figure 7: Molex Connector Descriptions................... 12
Figure 8: Open Collector Input Point Wiring
(Supervised) .................................................... 13
Figure 9: Open Collector Output Point Wiring
(Non-supervised) ............................................ 13
Figure 10: Dry Contact Input Point Wiring
(Supervised) .................................................... 14
Figure 11: Dry Contact Input Point Wiring
(Non-supervised) ............................................ 14
Figure 12: Typical Trouble Relay Connections
(Supervised) .................................................... 15
Figure 13: Typical Trouble Relay Connections
(Non-supervised) ............................................ 15
Figure 14: RJ31X Wiring.................................................. 16
Figure 15: Connecting a Keypad Programmer
to the FPT-DACT............................................. 17
Figure 16: System Fault/Fault on
Open Connections........................................ 23
Figure 17: FMR-DACT-KEYPAD..................................... 24
Figure 18: Additional Functions of the [Drill],
[Disable], and [Reset] Keys ........................ 25
Figure 19: Scrolling Main Menu .................................... 25
Figure 20: Exclusive Keys ................................................ 25
Figure 21: Shared Keys.................................................... 25
Figure 22: Submenu Items .............................................. 26
Figure 23: Event History Example.................................. 26
Figure 24: Programming Key Sequence for
System Date ................................................... 28
Figure 25: Programming Key Sequence Diagram ..... 29
Figure 26: 4/2 Point Report Example ........................... 40