EasyManua.ls Logo

Bosch FPT-DACT - Appendix B: 4;2 Reporting Codes; Table 10: 4;2 Reporting Codes

Bosch FPT-DACT
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN | 47FPT-DACT | Operation & Installation Guide |
1/05 | F01U002505B
Appendix B
Appendix B: 4/2 Reporting Codes
Table 10 lists the 4/2 codes supported by the FPT-DACT Fire Communicator. See RPT CODES for programming
information.
Table 10: 4/2 Reporting Codes
4/2 Report Code Keypad
Number Key
Group
Number
Definition
SYSTEM IN TST* [1] 1 System in Test. Sent for Walk Test operations.
SYS IN RPT* [2] 1 System in Test Restore. Sent for Walk Test operations.
SILENCE* [3] 1 Silence. Sent when the [SILENCE] key is pressed.
FIRE DRILL* [4] 1 Fire Drill. Sent for fire drill operations.
FIRE DRL RST* [5] 1 Fire Drill Restore. Sent for fire drill operations.
OPEN RST RPT [6] 1 Open Reset Report. Sent when the [RESET] key is pressed.
LOW BATTERY [7] 1 Low Battery: Sent when a low battery input is active.
LOW BATT RST [8] 1 Low Battery Restore. Restoral occurs when a low battery input is active.
AC FAILURE [9] 1 AC Failure. Sent when an AC Fail input is active.
AC FAIL RST [1] 2 AC Failure Restore. Restoral occurs for AC Failure.
AUTO TST RPT [2] 2 Automatic Test Report. Sent for automatic communicator tests.
OFF NORM TST [3] 2 Off Normal at Test. Sent if the control panel is off-normal at the Automatic
Test time.
PHONE 1 TRBL [4] 2 Phone Line 1 Trouble. Sent for Phone Line 1 problems.
PN 1 TRB RST [5] 2 Phone Line 1 Trouble Restore. Sent for Phone Line 1 problems.
PHONE 2 TRBL [6] 2 Phone Line 2 Trouble. Sent for Phone Line 2 problems.
PN 2 TRB RST [7] 2 Phone Line 2 Trouble Restore. Sent for Phone Line 2 problems.
SYSTEM TROUB* [8] 2 System Trouble. Sent for general system problems.
SYS TRB RST* [9] 2 System Trouble Restore. Sent for general system problems.
MAN TST RPT [1] 3 Manual Test Report. Sent for manual communicator tests.
DATA LOST RP [2] 3 Data Lost Report. Sent if events occur too rapidly.
EEPROM FAIL [3] 3 EEPROM Failure. Sent for EEPROM problems.
RESET REBOOT* [4] 3 System power up and reboot.
SMK PWR TBL [5] 3 Smoke Power Trouble. Sent for smoke detector power supply problems.
SMK PWR RSTR [6] 3 Smoke Power Trouble Restore. Sent for smoke detector power supply
problems.
GND FLT TRBL [7] 3 Ground Fault Trouble. Sent for ground fault trouble problems.
GND FLT RSTR [8] 3 Ground Fault Trouble Restore. Sent for ground fault trouble problems.
* Item is sent only when the FPT-DACT is configured to communicate with a D8024 or D10024/D10024A Analog FACP.
** Item is for future use.

Table of Contents

Related product manuals