Bosch FPT-DACT - Page 48

1/05 | F01U002505B
EN | 48FPT-DACT | Operation & Installation Guide |
Appendix B
Table 10: continued
4/2 Report Code
Keypad
Number Key
Group
Number
Definition
TRBL INP RPT [9] 3 Trouble Input Report. Sent when system fault input is active.
TRBL INP RST [1] 4 Trouble Input Report Restore. Sent when system fault input restores.
ANALOG SERVC [2] 4 Analog service.
ANALOG RESTR [3] 4 Analog restore.
EQUIP FAILR* [4] 4 Equipment Failure.: Sent for equipment failure problems.
EQUIP RESTOR* [5] 4 Equipment Restore. Sent for equipment failure problems.
NETWORK FAIL* [6] 4 Network Failure. Sent for network failure problems.
NETWORK RSTR [7] 4 Network Restore. Sent for network failure problems.
SENS BUS RPT* [8] 4 Sensor Bus Report.
SENS BUS RST [9] 4 Sensor Bus Restore.
RMT PGM FAIL** [1] 5 Remote Programming Failure. Sent when there are problems with remote
programming.
RMT PGM
SUCC**
[2] 5 Remote Programming Success. Sent when remote programming is
successful.
UNKNOWN
FAULT
[3] 5 Unknown Fault. Sent for problems of an unknown nature.
* Item is sent only when the FPT-DACT is configured to communicate with a D8024 or D10024/D10024A Analog FACP.
** Item is for future use.