Bosch rexroth 1 Series - Page 14

14/68 Safety instructions
Bosch Rexroth AG, A20V(L)O Series 1, RE 93100-01-B/2019-09-10
CAUTION
High noise development during operation!
Danger ofhearing damage, hearing loss!
The noise emission ofaxial piston units depends onrotational speed, working
pressure and installation conditions, among other factors. The sound pressure level
may rise above 70 dB (A) incertain application conditions.
▶ Always wear hearing protection near arunning axial piston unit.
Hot surfaces onaxial piston unit!
Risk ofburning!
▶ Allow theaxial piston unit tocool down sufficiently before touching it.
▶ Protect yourself with heat-resistant protective clothing, e.g. gloves.
Inappropriate routing ofcables and lines!
Risk ofstumbling and property damage! Improper routing ofcables and lines
can cause arisk ofstumbling aswell asdamage toequipment and components,
e.g.due tolines and connectors being torn off.
▶ Always install cables and lines inaway that nobody can fall over them, that
they are not bend ortwisted, do not chafe onedges and are not guided through
ducts with sharp edges without sufficient protection.
Contact with hydraulic fluid!
Danger tohealth / damage tohealth, e.g. eye injury, skin damage, toxication inthe
event ofinhalation!
▶ Avoid any contact with hydraulic fluids.
▶ When handling hydraulic fluids, thesafety instructions ofthelubricant
manufacturer need tobe observed atall times.
▶ Use your personal protective equipment (e.g. safety goggles, safety gloves,
suitable working clothes, safety shoes).
▶ Immediately seek medical attention, however, ifhydraulic fluid gets into your
eyes orblood circuit orif you swallow itaccidentally.
Escaping hydraulic fluid through leaking machine/system components!
Risk ofburning and risk ofinjury due toescaping hydraulic fluid jet!
▶ Depressurize therelevant machine/system component and repair theleak.
▶ Never attempt toblock orseal theleak orhydraulic fluid jet with acloth.
Danger from improper handling!
Slip hazard! Risk ofslipping onwet surfaces when climbing onthe axial piston unit.
▶ Never grab orclimb onto theaxial piston unit.
▶ Check how tosafely get ontop ofthemachine/system.