Bosch rexroth 1 Series - Removal and Replacement; Required Tools; Preparing for Removal; Performing the Disassembly

Removal and replacement 57/68
RE 93100-01-B/2019-09-10, A20V(L)O Series 1, Bosch Rexroth AG
11 Removal and replacement
11.1 Required tools
Removal can beperformed using standard tools. No special tools are necessary.
11.2 Preparing for removal
1. Decommission theentire system asdescribed inthe instruction manual for
themachine orsystem.
– Relieve pressure inthe hydraulic system according tothe instructions
ofthemachine orsystem manufacturer.
– Make sure therelevant system components are depressurized and de-energized.
2. Secure theentire system against being re-energized.
11.3 Performing thedisassembly
Proceed asfollows toremove theaxial piston unit:
1. Make sure you have theappropriate tools and wear personal protective
equipment.
2. Allow theaxial piston unit tocool down until itcan beremoved without danger.
3. For below-reservoir installation, before removing theaxial piston unit from
theentire system, seal theconnection tothe reservoir and/ordrain thereservoir.
4. Place adrip tray under theaxial piston unit tocollect any hydraulic fluid that
mayleak.
5. Disconnect thelines and collect theescaping hydraulic fluid inthe drip tray.
6. Remove theaxial piston unit. Use asuitable lifting device.
7. Completely drain theaxial piston unit.
8. Plug all openings.
11.4 Preparing thecomponents for storage orfurther use
▶ Proceed asdescribed inchapter6.2 "Storing theaxial piston unit" onpage26.