Bosch rexroth 1 Series - Commissioning; Initial commissioning

Commissioning 49/68
RE 93100-01-B/2019-09-10, A20V(L)O Series 1, Bosch Rexroth AG
8 Commissioning
WARNING
Danger while working inthe danger zone ofamachine/system!
Danger tolife, risk ofinjury orserious injury!
▶ Pay attention toand eliminate potential danger sources before commissioning
theaxial piston unit.
▶ Make sure noone isinthe danger zone ofthemachine/system.
▶ The emergency stop button for themachine/system should bewithin
theoperator's reach.
▶ Always follow theinstructions ofthemachine/system manufacturer during
commissioning.
CAUTION
Commissioning animproperly installed product!
Risk ofinjury and property damage!
▶ Make sure all electrical and hydraulic ports are connected orplugged.
▶ Commission only afully installed, fully functioning product with original
accessories from BoschRexroth.
8.1 Initial commissioning
During all commissioning work onthe axial piston unit, observe thegeneral safety
instructions and intended use detailed inchapter2 "Safety instructions"
onpage9.
▶ Connect thepressure gauge for theworking pressure, case pressure and suction
pressure tothe specified measuring points onthe axial piston unit orinthe
hydraulic system, tocheck thetechnical data atfirst operation.
▶ During commissioning, monitor thetemperature ofthehydraulic fluid inthe
reservoir toensure that itlies within permissible viscosity limits.
8.1.1 Filling theaxial piston unit
Professional filling and air bleeding isnecessary toprevent damage tothe
axialpiston unit and tomaintain proper function.
Usually, thecleanliness level ofcommercial hydraulic fluids isinsufficient for our
components. These hydraulic fluids must befiltered during filling using
anappropriate filter system tominimize solid particle contamination and water
inthe system.