Bosch rexroth 1 Series - Troubleshooting; 14.1 How to proceed for troubleshooting

60/68 Troubleshooting
Bosch Rexroth AG, A20V(L)O Series 1, RE 93100-01-B/2019-09-10
14 Troubleshooting
Table 21 isintended tosupport troubleshooting. This table isnot exhaustive.
Issues may occur inpractice that are not listed here.
Only authorized personnel may perform troubleshooting inside asafety area
designated bythemachine manufacturer.
14.1 How toproceed for troubleshooting
▶ Perform troubleshooting ifpossible with reduced operating data
(e.g.slowlyswinging inor out and slow pressure increase).
▶ Use asystematic and targeted approach, even when pressed for time. Random,
indiscriminate removal and changing ofsettings could make itimpossible
todetermine theoriginal cause ofthefault.
▶ First get ageneral idea ofhow your product works inconjunction with
theentiresystem.
▶ Try tofind out whether ornot theproduct was working properly inconjunction
with theentire system before thefault occurred.
▶ Try todetermine any changes tothe entire system inwhich theproduct
isinstalled:
– Have there been any changes tothe application conditions oroperating range
oftheproduct?
– Has maintenance work recently been carried out? Is there aninspection
ormaintenance log?
– Have any changes (e.g. upgrades) orrepairs been made tothe overall system
(machine/system, electrics, control) ortothe product? Ifyes: What changes?
– Has thehydraulic fluid been changed?
– Has theproduct ormachine been used asintended?
– How does themalfunction appear?
▶ Try toget aclear idea ofthecause ofthefault. Directly ask the(machine)
operator.
▶ Document thework carried out.
▶ If thefault cannot becorrected, please refer toone ofthecontract addresses
at:
www.boschrexroth.com/addresses.