EasyManua.ls Logo

Bosch rexroth 1 Series - 10.3 Maintenance

Bosch rexroth 1 Series
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance and repair 55/68
RE 93100-01-B/2019-09-10, A20V(L)O Series 1, Bosch Rexroth AG
Table 20: Inspection schedule
Tasks tobe performed Interval
Hydraulic system Check hydraulic fluid level inthe reservoir. Daily
Check theoperating temperature under comparable load
condition atthedrain port and inthe reservoir.
Weekly
Conduct hydraulic fluid analysis: Viscosity, aging and
contamination
Yearly orevery
2000 operating
hours (whichever
occursfirst)
Check filter.
The replacement interval may vary depending onthe
cle
anliness ofthehydraulic fluid. We recommend using
acontamination indicator.
Yearly orevery
1000 operating
hours (whichever
occursfirst)
Axial piston unit Check axial piston unit for leakage.
Early detection ofhydraulic fluid loss can help tofind
fault
s onthe machine/system and rectify them. This
iswhy BoschRexroth recommends always keeping
theaxial piston unit and system clean.
Daily
Check axial piston unit for unusual noise development. Daily
Check mounting elements for tight seating.
All fasteners have tobe checked when thehydraulic
sy
stem isswitched off, depressurized and cooled down.
Monthly
10.3 Maintenance
The axial piston unit islow-maintenance when used asintended.
The service life oftheaxial piston unit isheavily dependent onthe quality
ofthehydraulic fluid. This iswhy we recommend changing thehydraulic fluid atleast
once per year orevery 2000 operating hours (whichever occurs first), orhaving
itanalyzed bythehydraulic fluid manufacturer oralaboratory todetermine its
suitability for further use.
The service life oftheaxial piston unit islimited tothe service life ofthebearings
used. You can ask your local contact person about service life based onload cycle.
You can find their contact information at
www.boschrexroth.com/addresses
Based onthese details, amaintenance interval should bedetermined
bythesystem manufacturer for thereplacement ofthebearings and included
inthe maintenance schedule ofthehydraulic system.

Table of Contents

Related product manuals