Bosch rexroth 1 Series - Safety instructions; 2.2 Intended use; 2.3 Improper use

Safety instructions 9/68
RE 93100-01-B/2019-09-10, A20V(L)O Series 1, Bosch Rexroth AG
2 Safety instructions
2.1 About this chapter
The axial piston unit has been manufactured togenerally accepted engineering
standards. There isstill, however, arisk ofpersonal injury orproperty damage
ifthischapter and thesafety instructions inthis documentation are not observed.
▶ Read this documentation completely and thoroughly before working with
theaxialpiston unit.
▶ Keep this documentationinalocation where itisaccessible toall users
atalltimes.
▶ Always include therequired documentation when you pass theaxial piston unit
onto third parties.
2.2 Intended use
Axial piston units are hydraulic components, meaning that intheir application
area they are classified neither ascomplete nor aspartly completed machinery
asdefined inthe EC Machinery Directive2006/42/EC. The component isexclusively
intended toform partly completed machinery orcomplete machinery together with
other components. The component should only becommissioned after ithas been
installed inthe machine/system for which itisintended and thesafety oftheentire
system has been established inaccordance with theMachinery Directive.
This product isintended for thefollowing use:
The axial piston unit isonly approved asapump for hydrostatic drives inanopen
circuit. For combined operation as pump and motor, please contact us.
▶ Adhere to the technical data, the application and operating conditions, and
the performance limits as specified in 93100 and in the order confirmation.
Information on approved hydraulic fluids can be found in 92703 (size 60),92500
(sizes 95, 190 and 260) and 92050 (size 520).
The axial piston unit isonly intended for commercial use and not for private use.
Intended use includes having fully read and understood this documentation,
especially chapter 2 "Safety instructions" onpage 9.
2.3 Improper use
Any use other than that described asintended use isconsidered improper.
BoschRexrothAG isnot liable for damages resulting from improper use. The user
issolely responsible for any risks arising from improper use.
The following foreseeable forms offaulty usage are also considered improper
(thislist isnot exhaustive):
• Use outside theoperating parameters approved inthe data sheet andinthe order
confirmation (unless specifically approved bythecustomer)
• Use ofnon-approved fluids, e.g. water orpolyurethane components
• Changes tofactory settings byunauthorized persons.
• Use ofassembled parts (e.g. control unit, valves) not incombination with
thespecified Rexroth components