Bosch rexroth 1 Series - Page 27

Transport and storage 27/68
RE 93100-01-B/2019-09-10, A20V(L)O Series 1, Bosch Rexroth AG
An uninstalled axial piston unit must bepreserved with corrosion protection for
theduration ofstorage.
The following instructions only refer toaxial piston units operated with
hydraulicfluid onamineral oil basis. Other hydraulic fluids require other specific
preservation measures. In such acase, consult your local contact person; you can
find their contact information at
www.boschrexroth.com/addresses
BoschRexroth recommends thefollowing procedure:
1. Clean theaxial piston unit; see chapter10.1 "Cleaning and care" onpage54.
2. Drain theaxial piston unit.
3. For storage times up to12 months: Moisten theinside oftheaxial piston unit
with mineral oil and fill with approx. 100 ml mineral oil.
For storage times up to24 months: Fill theaxial piston unit with VCI329
corrosion protection (20 ml).
Filling isdone through the drain port L
1
, L
2
, L
3
, or L
4
and/or T
1
or T
2
and/or R(L)
1
or R(L)
2
, see chapter7.4 "Installing theaxial piston unit", Fig. 19 to Fig. 21 on
page43.
4. Plug all ports so they are airtight.
5. Coat unpainted areas oftheaxial piston unit with mineral oil orsuitable,
easilyremovable corrosion protection, e.g. acid-free grease.
6. Package theaxial piston unit with desiccant incorrosion protection film soit
isairproof.
7. Store theaxial piston unit inashock-proof manner; see "Requirement"
onpage26 inthis chapter.
After removal