Bosch rexroth 1 Series - Page 47

Installation 47/68
RE 93100-01-B/2019-09-10, A20V(L)O Series 1, Bosch Rexroth AG
Exact details onthe connector, type ofprotection and matching mating connector
can also befound indata sheet 93100. The mating connector isnot included inthe
scope ofdelivery.
1. Switch off thepower supply tothe relevant system component.
2. Electrically connect theaxial piston unit (12 or24V). Before establishing
theconnection, check whether theconnector protective covers have been
removed and theconnector and all seals are intact.
For more far-reaching information that is not contained in data sheet 93100
please refer to the following data sheets:
– Data sheet 92703 for size 60
– Data sheet 92500 for sizes 95 to 260
– Data sheet 92076 for size 520
If necessary, you can change theposition oftheconnector byturning thesolenoid
body. This isindependent oftheconnector version.
CAUTION! Hot surfaces onthe solenoid!
Risk ofburning!
▶ Allow thesolenoid tocool down sufficiently before touching it.
▶ Protect yourself with heat-resistant protective clothing, e.g. gloves.
To do this, proceed asfollows:
1. Loosen themounting nut(1) ofthesolenoid. To do this, turn themounting
nut(1) one turn counter-clockwise.
2. Turn thesolenoid body(2) tothe desired position.
3. Re-tighten themounting nut. Tightening torque ofthemounting nut: 5+1Nm.
On axial piston units with aHirschmann connector according
toDIN EN 175 301-803-A/ISO 4400, thefollowing tightening torques apply when
mounting plug-in connectors:
• Mounting bolt M3(1): 0.5 Nm
• Union nut M16×1.5(2): 1.5–2.5Nm
1
2
Fig. 22: Hirschmann connector
Changing connector
position
1
2
Tightening torque for
Hirschmann connectors