Bosch Rexroth therefore recommends to use screw connections with an O-ring
to seal the screw connection in axial direction.
Seals consisting of hemp, teflon tape or cone-shaped screw connections are not
considered to be suitable, since this type of seal may stress the connection
thread at the motor to an unreasonably high extent.
The machine manufacturer is responsible for ensuring that the cool-
ant connection is tight and for verifying and accepting the tightness
after the motor has been installed.
Notes for assembly for coolant ducts
● Fix lines in regular intervals.
● Coolant ducts must not contact live parts. Refer to"Potential equalization" on
page 16.
80/101
Assembly
MS2N Synchronous Servomotors
Bosch Rexroth AG R911347581_Edition 04
To Next Page
Loading...
