Bosch Rexroth MS2N - Mechanical Interfaces

4.2.2 Mechanical interfaces
ØG
ØC
A
B
D
E
ØF
Type A
☐ Flange
[mm]
B
Length
[mm]
C
Shaft Ø
[mm]
D
Shaft length
[mm]
E
Centering
collar [mm]
F
Hole circle
[mm]
G
Mounting
hole [mm]
MS2N03-B
58
See specifi-
cations
9 20
40 63 4.5
MS2N03-D 11 23
MS2N04 82 14 30 50 95 6.6
MS2N05 98 19 40 95 115 9
MS2N06 116 24 50 95 130 9
MS2N07 140 32 58 130 165 11
MS2N10 196 38 80 180 215 14
MS2N13 260 48 80 255 300 18
1)
Additional documentation DOK-MOTOR*-MS2N*******-PRIX-EN-P, Project Planning Manual
Tab. 4-2: Mechanical interface flange, shaft
Use the following screws and washers for flange assembly.
Screw
1)
M4 M6 M8 M10 M12 M14
Mounting holes ⌀ [mm] 4.5 6.6 9 11 14 18
Tightening torque M
A
[Nm] at μ
K
= 0.12
3.0 10.1 24.6 48 84 206
Washer - - Yes Yes Yes Yes
1)
Screws according to DIN EN ISO 4762 or DIN EN ISO 8.8. Property class 8.8. The screw lengths depends on
material and installation situation. The specified tightening torque must be ensured.
Tab. 4-3: Tightening torque of mounting screws
12/101
About this product
MS2N Synchronous Servomotors
Bosch Rexroth AG R911347581_Edition 04