● The balancing state of transmission elements must comply with the full-key
balancing of the motors.
Motor damage due to strikes onto the motor
shaft
Do not strike the shaft end and do not exceed the allowed axial and
radial forces of the motor.
Fitting
Fig. 6-2: Fitting the transmission element
Use the centering hole for fitting transmission elements. For details on centering
holes, please refer to the project planning manual. If necessary, heating up the
transmission element.
MS2N Synchronous Servomotors
51/101
Assembly
R911347581_Edition 04 Bosch Rexroth AG
To Next Page
Loading...
