6-6 Operator control and visualization REFUspeed RS51
DOK-RD500*-RS51*******-IB02-EN-P
6.3 Monitoring
Monitor
0.00 Hz
0.00 A
0.00 Hz
PARAMETER
D 0012
Frequency output
0.00 Hz
MONITOR
parameter
fault memory
plots
copy status
locate D-parameter
differenz Std-value
D 0012
D 0014
P 0046
P 0024
MONITOR
parameter
fault memory
plots
FAULT MEMORY
F0:
DC-link volt.low
123h 49min
FAULT MEMORY
F1:
SR <==> WS new
100h 30min
MONITOR
fault memory
plots
copy status
PLOTS
U/f-characteristic
U/f-
character
Setting the parameter number:
The cursor position is moved using the
or key.
The appropriate number is set using the
U
MONITOR
plots
copy status
locate D-parameter
COPY STATUS
no failure
MONITOR
copy status
locate D-parameter
differenz Std-value
LOCATE D-PARAMETER
D 180 1
LOCATE D-PARAMETER
D 180 1
P 0263.00
Src main set point
MONITOR
copy status
locate D-parameter
differenz Std-value
DIFFERENZ P0181.01
Kennlinie fa
Std: 0.0 Hz
Akt: 1.5 Hz
DIFFERENZ P0181.00
V/f characterist.Fa
std: 0.0 Hz
akt: 1.5 Hz
12 : 0.00 Hz
14 : 0.0 A
46 : X.X A
24 : X.X A
D 0012
D 0014
P 0046
P 0024
Mon
Parameterization can be selected
from every menu item by pressing the
key
Esc
Enter
Mon
Esc
Prog
or key.
Fig. 6-8: Monitor program structure
Monitor functions
Any four selected parameters are simultaneously displayed. The pa-
rameter monitor can be advantageously used during commissioning, e.g.
the frequency setpoint route can be tracked using the parameterizable
functions of the drive. In this case, use the D parameters from the func-
tion charts.
Parameter
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
To Next Page
Loading...
Need help?
General
