REFUspeed RS51 Operator control and visualization 6-5
DOK-RD500*-RS51*******-IB02-EN-P
ESC
START STOP
MON ENTERPROG
-
+
ALARM
ON
READY
P0733
P0732
AP520013DE00.FH9
Fig. 6-7: Copy function
Note: After Copy, can be checked over Monitor copy-Status if faults
be arise at the transmission
Fault acknowledgement
After a fault/error occurs, “Fault” is displayed in the operating display. The
cause of the fault and the fault time are displayed below this. The
Esc
key on the operator panel can be used to acknowledge the fault after the
cause of the fault has been removed.
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
To Next Page
Loading...
Need help?
General
