REFUspeed RS51 Basic parameterization 7-25
DOK-RD500*-RS51*******-IB02-EN-P
Diagnostics / drive data
Parame-
ter No.:
Name Description / explanation
selectable options
Factory setting
min ... max values
Pass
wor
d
0028 Operating hours
Operating hours with the inverter enabled.
0h
0 ... 2147483647 h
-
0024 Continuous current
0025 Peak current, long
0046 Peak current, short
0022 Continuous output
0023 Peak output, long
0099 Max. o/p frequency
0027 Max. normaliz. freq.
Device data correspond to the drive converter per-
formance data
0
0001 Device ID 501
0002 Firmware version e.g. 2
0003 Firmware module
Firmware data
e.g. 2
0006 Serial number e.g. 3
0007 Converter number e.g. 1
0
0008 EEPROM prog. cy-
cles Displays the EEPROM programming cycles
1
-1 ... 100000
-
0040.0n Fault memory
n=0...9(thelast10faults)
No fault
0 ... 64
0
0898 Scratchpad REFU
Can be used to save any number.
0.000
0.000 ...
2147483.647
2
0899 Scratchpad customer
Can be used to save any number.
0.000
0.000 ...
2147483.647
2
Options
These are only displayed if the actual option is available. The parameters
are described in the associated option description.
7.5 Numerical list
All of the basic parameterization parameters can be directly selected in
the numerical list using the parameter number (refer to the structure of
the basic parameterization).
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
To Next Page
Loading...
Need help?
General
