29
Bosch Security Systems 6/09 BLCC500U FTR1.03
Solution 16 i User Guide
System > Clock >
ST-On
Summer Time On
MENU 7-1-1
This menu allows you to program when day light savings
start during the year. This will allow the control panel to
automatically adjust it’s built in clock accordingly. See
the section on Australian daylight savings times for more
information.
To program Summertime On, you will need to set the
month of the year (Jan to Dec), the week of the month
(1 to 5) and the day of the week (Sun to Sat) that daylight
savings starts.
January = Month 1 December = Month 12
First Week = 1 Last Week = 5
Sunday = Day 1 Saturday = Day 7
1. Enter your Master PIN + [MENU.
2. Enter [7] + [1] + [1] + [OK].
MM =10
3. Enter the number of the month (January = 01 /
December = 12) that Summer Time starts.
WW =05
4. Enter the number of the week (First Week = 1 / Last
Week = 5) in that month that Summer Time starts.
dd =01
5. Enter the number of the day in the week (Sunday =
01 / Saturday = 07) Summer Time starts
6. Use the [←] and [→] keys at any time to conrm
programming and then press [OK] to exit.
Australian Daylight Savings Times
From 2008, the ACT, NSW, South Australia, Victoria
and Tasmania will all start daylight savings on the
rst Sunday in October and end on the rst Sunday
in April. This will result in an extra month of daylight
savings for the ACT and introduces common start
and nish dates in these states.
For Western Australia, a three year trial of daylight
savings began on Sunday December 3, 2006. A
referendum will be held in 2009 to decide whether it
should become permanent.
Daylight Saving Begins Daylight Saving Ends
Turn Clock Ahead 1 hr Turn Clock Back 1 hr
Sunday 4 October 2009 Sunday 4 April 2010
Sunday 3 October 2010 Sunday 3 April 2011
System > Clock >
St-Off
Summer Time Off
MENU 7-1-2
This menu allows you to program when day light
savings end during the year. This will allow the panel to
automatically adjust it’s built in clock accordingly.
To program Summer time O, you will need to program the
month of the year (Jan to Dec), the week of the month (1 to
5) and the day of the week (Sun to Sat) that daylight saving
ends.
1. Enter your Master PIN + [MENU].
2. Enter [7] + [1] + [2] + [OK].
MM =03
3. Enter the number of the month (January = 01 /
December = 12) that Summer Time ends.
WW =05
4. Enter the number of the week (First Week = 1 / Last
Week = 5) in that month that Summer Time ends.
dd =01
5. Enter the number of the day in the week (Sunday =
01 / Saturday = 07) Summer Time ends.
6. Use the [←] and [→] keys at any time to conrm
programming and then press [OK] to exit.