34
*
You can also adjust the volume of the microphone or
external input by rotating the CONTROL knob while
holding down the CANCEL button.
In
this
way, however, the PEAK indicator do not light, so
adjust the volume as you actually listen to the sound.
3.
Press
the CANCEL
button.
2. Rotate the CONTROL knob
to
adjust the input
level.
Rotating it toward the left will decrease the level, and
rotating it toward the right will increase the level. Adjust
the level so that the PEAK indicator lights occasionally.
1.
Press
the REC
button.
The button will blink.
If
distortion occurs because the input level is too high, or
noise is a problem because the input level
is
too low, you can
adjust the input level.
e
If
noise is
a
problem
6. When you no longer wish
to
apply the effect,
press the button
once again to make it go dark.
5,
Press either the
FILTER
1,
FILTER
2
or RING
MOD button
to make the
button
light.
4. Rotate the
SP-202's VOLUME to an
appropriate
level, and while gradually raising
the
volume of
your amp or monitor speaker, speak into the
microphone or playback the
CD, etc.
3,
Press the
SOURCE
pad
to
make
the
pad light.
2.
If you wish
to
apply the
effect to the mic
input,
set the
SOURCE SELECT
switch
to MIC.
If you
wish
to
apply the effect
to
the
line
input
(LINE
IN), set the
SOURCE SELECT
switch to
LINE.
Then tum the power switch
ON.
1.
Tum
the SOURCE MIX
switch
OFF
.
Filter
1
or
2
or the ring modulator (only one of these at
a
time) can be applied to the external input of the
SP-202.
I
Applying
an
effect to
the
external input
•
Ring
modulator cannot be used in the following situa-
tions
• On stereo samples that were recorded to banks
CID
• When reverse playback is used
*
The ring modulator effect can be adjusted independently
for each sample.
3,
Rotate the CONTROL knob to adjust the ring
modulator
effect.
2.
Press
the
RING
MOD button to make the button
light.
1.
Press
the pad which contains the sample
to
which
you wish to apply the ring modulator. (Specify
the current pad)
The pad will light, and the sample will play.
3
CONTROL
EFFECTS
By
using the ring modulator, you can create special effects
such as changing
a
human voice into
a
mechanical-sounding
robot voice, or apply it to
a
phrase to modifying the sense of
pitch.
By
modifying this in time with the rhythm, you can
also create unique accents.
I
Using
the ring modulator
To Next Page
Loading...