Wraptor A6200 User Manual 17
Setup
Loading Label Supply
Loading Label Supply
Brady labels come equipped with smart-cell technology that enables the printer and Brady labeling
software to recognize the type of label and automatically set many label formatting details.
Use only genuine Brady A62 series labels.
To load labels:
1. Turn the printer on and tap Load Supplies on the home screen, then tap Load Supply. (See
“Using the Touch Screen” on page 25.)
2. Pull up on the latch and lift open the cover on the printer.
3. Remove the existing label roll. (The printer comes with a liner installed in the label path. Note
the correct placement before removing it.)
a. Leave at least six inches of empty liner on the end of the roll. You will need the length of
empty liner when installing this roll again in the future.
b. Press the gray button on the front of the printer to open the wrapper module.
c. Press the yellow button to open the peeler door.
peeler door closed
peeler door open
To Next Page
Loading...
