©2013 Brooks Automation Inc. Pub. No. 8040444, Rev. AA, 01/14/2013 ECO No. 63723 C-1
Document Title
Appendix C - Troubleshooting Procedures
Troubleshooting the Compressor
The compressor troubleshooting procedures are summarized in Table C-1.
Technical Inquiries
Please refer to “Appendix A: Customer Brooks Automation Technical
Support Information” of this manual for a complete list of the
BROOKS-CRYOGENICS’ world wide customer support centers.
WARNING
Disconnect the compressor before performing any troubleshooting
procedures.The compressor pump is hot after operating. Wait for the
pump to cool down before working on the inside of the compressor
Do not change or modify any compressor internal wiring circuits, this
may cause failure of the compressor and cold head due to improper
phasing.
To Next Page
Loading...