• Install a scanning application (for example, Brother iPrint&Scan) and configure the settings using the
application before scanning from the machine.
• If your machine is connected via a network, we recommend using Web Based Management to configure
the Scan Destination setting.
5. USB LED
It is lit when the Scan to USB function is available.
6. Feed Selector ( (ADF Mode)/ (Plastic Card Mode) )
Slide to select the scanner feed mode.
ADS-1350W
1. Error LED
It flashes when the machine detects an error.
2.
(Power On/Off)
Press to turn the machine on.
Press and hold to turn the machine off.
3.
(Stop)
Press to stop your current action and return to Ready Mode.
4.
(WPS)
If your wireless access point/router supports WPS (Wi-Fi Protected Setup), press to connect your
machine to the wireless access point/router.
5. Wi-Fi LED
• It flashes when your machine is enabled for a wireless network.
• It remains lit when your machine is connected to a wireless access point or to the wireless network using
Wireless Direct.
6. Device Scan Buttons
•
Button 1
11
To Next Page
Loading...
