Brother BAS-340 - Page 35

[11 Feed mechanism (X axis) (2)
3) After applying grease to the X-retainer @I place steel balls (5/32") @ on the X-retainer @ respectively.
Using caution that no steel balls (5/32") @ drop out of the X-retainers @I assemble them to X-feed
guides (F) G) and (R) ®.
NOTE: Wire together the retainer and the feed guide. Attaching to the bed will be easier.
4) Place the back side of X-feed guide (R) @ on the mounting reference planes in the bed and attach X-
feed guide (R)@ to the bed with the bolt~.
5) Put the X-feed bracket 0 between X-feed guides (F) G) and (R) @ and attach X-feed guide (F) G) to the
bed with the bolt ~.
6) Attach the bolt® for adjustment and the nut@ to the arm as in figure above.
7) Attach the X-stoppers tiD to the ends of X-feed guides (F) ID and (R)@ with the screws fD.
NOTE: At this time, the screwsfD should be temporarily tightened.
-32-
From the library of: Superior Sewing Machine & Supply LLC