Brother DCP-L2500D - Page 59

2-24
Confidential
Jam Inside Open the Front Cover,
pull out the Drum Unit
and remove the
jammed paper.
The eject sensor does not detect
paper pass after the registration
rear sensor detected the paper
pass.
7000 2-44
Jam Rear Open the Back Cover
and remove the
jammed paper, then
press [Retry].
The eject sensor remains ON
(paper pass detected) even after
the registration rear sensor
detected the end of paper pass.
7100 2-45
Jam Tray Remove the jammed
paper from Tray.
When printing from the paper tray,
the registration front sensor does
not detect paper pass within the
specified time after the paper feed
sensor detected paper pass.
7300 2-45
Machine Error **
- A machine error occurred.
Refer to the error code “**”.
--- ---
Manual Feed Load Paper in Manual
Feed.
There is no paper set in the manual
feed slot on the manual feed slot fix
mode.
8C00 2-48
No Paper Reload paper in Tray. When printing from the paper tray,
the paper feed sensor detected
that there was no paper set in the
paper tray.
9302 2-49
No Toner Open the Front Cover,
then install the Toner
Cartridge.
The new toner sensor detected
that the toner cartridge was not set. 6101 2-41
Out of Memory Press stop[x]. There is insufficient memory to
expand PC print data.
C700 2-55
Phone line may
not be connected
Check line connection.
Refer to User's Guide.
Auto-detect ended without
detecting the line voltage.
--- 2-94
Print Data Full Print Data is full. Press
Stop[x] and delete the
previously stored data.
The memory size allotted for
Secure print was exceeded when
saving Secure print data.
C800 2-55
Print Unable ** Printing error
Refer to the error code “**”.
--- ---
Replace Toner Open the Front Cover,
replace Toner
Cartridge.
Dot count or develop roller counter of
the toner has reached the upper limit
in the toner stop mode.
4C01 2-39
Scan Unable ** Scanning error
Refer to the error code “**”.
--- ---
Scanner Error
- Detected that the first or second
side CIS flat cable was not inserted
correctly when function code 55
was executed.
B000 2-53
A white level not within the
standard was scanned when
function code 55 was executed.
BB00 2-54
A black level not within the
standard was scanned when
function code 55 was executed.
BD00 2-54
Error Messages
Description
Error
codes
Refer
to:
Upper line Lower line