Brother DCP-T430W - Page 160

LED Status Cause Action
(Copy Shortcut)
simultaneously for three seconds.
If the Ink LED is lit or flashing,
press (Stop).
See Related Information: Refill the
Ink Tanks.
Use the ink level notification
display feature:
• To enable the notification, press
(Paper) and the Mono
Copy button simultaneously.
The Power LED flashes three
times.
• To disable the notification, press
and hold
(Paper) and the
Mono Copy button
simultaneously for three
seconds. The Power LED
flashes three times.
(DCP-T430W/
DCP-T435W/
DCP-T436W/
DCP-T439W)
Ink volume
warning
The machine is still in use, but the
“Check ink volume” indication, listed
above, has not been cleared.
If the remaining ink level is at or
below the lower line under the
minimum fill mark, refill the ink
tank.
After refilling all of the ink colours,
press and hold
(Paper) and
(Copy Shortcut)
simultaneously for three seconds.
If the Ink LED is lit or flashing,
press (Stop).
See Related Information: Refill the
Ink Tanks.
Use the ink level notification
display feature:
• To enable the notification, press
(Paper) and the Mono
Copy button simultaneously.
The Power LED flashes three
times.
• To disable the notification, press
and hold
(Paper) and the
Mono Copy button
simultaneously for three
seconds. The Power LED
flashes three times.
(Flashing
simultaneously)
Out of memory The machine's memory is full. If a copy operation is in progress:
• Press
(Stop) and wait until
the other operations that are in
progress finish, and then try
again.
• Press the Mono Copy or
Colour Copy button to copy the
pages scanned so far.
155