Brother GTX pro - Confirmation and Refilling of Cleaning Solution

117
Basic printing procedures
6-2-2. Confirmation and refilling of cleaning solution
Check to see if the amount of cleaning solution is kept at a proper liquid level in the cleaning liquid tank, and refill the
tank with the solution when its amount is below the proper level.
<TIPS>
 Also, refill the tank with the solution when a warning message appears on the operation panel screen or in the warning message
window when the cleaning liquid tank is not pulled out.
(1) Pull out the cleaning liquid tank from the side of the printer.
(2) Open its lid and refill it with the cleaning solution up to the "FULL" line.
<IMPORTANT>
 Be sure not to put the cleaning solution into the tank above the "FULL" line.
FULL
LOW
X0044
(3) Close the lid and slowly place the cleaning liquid tank into the printer.
Cleaning solution
Cleaning liquid tank