238
What to do when needed
8-17. Static IP address setting
In the [IP Address Set] window, select the manual setting or automatic acquisition, and set up the [IP Address], [Subnet
Mask] and [Default Gateway] when you select the manual setting.
(1)
From the menu, select [Printer Setting] > [IP Address Set], and press
.
(2)
Select either [Manual setting] or [Automatic acquisition] and press
.
<TIPS>
If you select [Automatic acquisition], the screen will go back to the standby mode screen after the settings are automatically
acquired.
(3)
To make manual settings, press
to move to and select your desired position.
(4)
To make manual settings, press
to specify your desired numeric value.
(5)
When the
button is pressed, the selected value is accepted, and the display screen goes to the [IP
Address], [Subnet Mask] and [Default Gateway] in an orderly manner.
<TIPS>
The display screen shown here has been taken as an example.
To Next Page
Loading...
