Brother GTX pro - Sending Print Data Using Brother GTX Pro Fileoutput (for Macintosh Only)

69
Creating print data
5-2. Sending print data using Brother GTX pro FileOutput (for Macintosh only)
Saving print data to a file
When using the "Brother GTX pro FileOutput" printer to save print data to a file, be sure to perform the save operation
with the " GTX pro FileViewer" being activated.
If you try to output and save the data to a file without activating the " GTX pro FileViewer", an error shown below will
occur and the file cannot be saved to the system.
<TIPS>
 Not all applications display an error message. If that is the case, start the "GTX pro FileViewer" and try again.
<TIPS>
 The procedures to output a file from the "Brother GTX pro FileOutput" are the same as those for Windows PC.
Transmission of print data
Send such print data that has been saved using the "Brother GTX pro FileOutput" printer to the printer by performing the
procedures mentioned below.
<TIPS>
 The procedures to send the print data are the same as those for Windows PC.
(1) Double-click on a file with the extension ".arxp" assigned to its filename which has been saved by means of the
"Brother GTX pro FileOutput" printer.
(2) Subsequently, the " GTX pro FileViewer" starts working, then, under that condition, click on the [Send to Printer],
which results in the file transmission.