Brother GTX pro - Sending Print Data from Applications

155
Basic printing procedures
6-6-2. Sending print data from applications
CorelDRAW
(1) In the menu bar, select [File] > [Print].
(2) Open the [Color] tab, and make the following settings:
 Place a checkmark in the [Document color] checkbox.
 [Color conversions]: "Brother GTX pro" or "Brother GTX pro FileOutput"
 [Color profile]: [sRGB IEC61966-2.1]
 [Rendering intent]: [Relative colorimetric]
(3) Open [General] tab and select "Brother GTX pro" from [Printer].
<TIPS>
 If the specified [Printer] is set to "Brother GTX pro", the print data will be sent to the printer.
If the specified [Printer] is set to "Brother GTX pro FileOutput", the print data will be saved as an ARXP file.
(4) On [Preferences], set up the printer driver and send the print data by clicking [OK] in the [Print] dialog box.
<TIPS>
 Setting the printer driver ☞"5-4. Set up the printer driver >>P.89"
 Clicking on [OK] will not start the print operation of the printer itself. The print button of the printer should be pressed to start
the printing operation.