Brother GTX pro - When Using Adobe Illustrator

83
Creating print data
5-3-3. When using Adobe Illustrator
In Illustrator, perform the required procedures mentioned below:
 Color setting
 Open a new file
As required, perform the following procedures:
 Create print data (ARXP file)
 Use the color palette
<TIPS>
 Take one of the actions mentioned below, in order to avoid such troubles that no image data is inserted into the print range or part
of image data is cut off.
- Before start-up, specify the PC's default printer as the "Brother GTX pro" or the "Brother GTX pro FileOutput".
- Use the "Brother GTX pro FileOutput" printer driver to output a file, then display and check the print preview.
 For an image created in CMYK color mode, load the image into Photoshop, select [Image] > [Mode] in the menu bar, and change
the color to the RGB color (sRGB). In order to edit an image, load the image into the Photoshop, edit it in the form of bitmap data,
or edit it by means of the image quality improvement of printer driver (☞"5-4-9. Set up the image quality >>P.103").
 For this printer, it is recommended to use Illustrator CC2020/CC2019. The display screen is described assuming Illustrator
CC2020.