EasyManua.ls Logo

Brother GTX pro - Daily Agitation of the White Ink

Brother GTX pro
356 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
118
Basic printing procedures
6-2-3. Daily agitation of the white ink
Perform the procedures shown below if a white ink cartridge stirring message is displayed before starting operation.
(1) Take out the white ink cartridge from the printer.
<CAUTION>
The bottom of the cartridge may be soiled with ink. Clean the printer on a regular basis.
W12 W34
X0317
(2) Shake the cartridge 100 times side by side to stir the white ink.
<IMPORTANT>
The white ink cartridge should be held horizontally when shaking it.
Holding the white ink cartridge upside down or shaking it too roughly could break the ink pouch.
<NOTE>
Wear the provided gloves when performing this task.
When the remaining ink level becomes approximately 5.9 in. (15 cm), shake the cartridge with its cover open and with the
edge of the ink pouch slightly winded, to make the ink easier to stir.
X019
4
White Ink Cartridge
White Ink Cartridge
Shake 100 times (for approx. 50 seconds)
(Swing distance should be approx. 2 in. (5 cm).
Increase the swing distance when the
remaining ink level becomes low.)
Ink pouch
Edge of the rib
Remaining ink volume should
be approx. 5.9 in. (15 cm)

Table of Contents

Other manuals for Brother GTX pro

Related product manuals