191
Precautions to keep good printing quality/use printer over the long term
(8)
Assemble a new flushing foam to the flushing receiver.
<IMPORTANT>
After this assembly process is completed, make sure that no flushing foam extends off the outboard end portions of flushing
receiver. If it sticks out of the end portions, it may interfere with any nozzles and may result in non-ejection of ink-jet
droplets.
<TIPS>
It is not necessary to clean the flushing receiver.
X033
(9)
Close the front cover.
(10)
Turn on the power.
<NOTE>
Dispose of any waste resulting from the replacement in accordance with applicable laws and ordinances.
<TIPS>
The head cleaning will be performed to prevent ink from drying up.
Flushing receiver
To Next Page
Loading...
