288
Troubleshooting
(15) Remove the core claw using the supplied screwdriver.
<TIPS>
Hold the core center by hand to make it easy to insert the screwdriver into the claw.
X040
(16) Remove the resin cover which is placed on the top of the carriage board and remove the flat cable.
X040
(17) Unlock the print head, and remove the print head.
<IMPORTANT>
When removing the print head, be careful not to drip the ink on the carriage plate. If the ink is dripping, wipe off the dripping
ink.
②
①
X041
Lock
Print head
Resin cover
Flat cable
Driver
Core
Latch
To Next Page
Loading...
