296
Troubleshooting
(33)
Close the lid, and put the white ink cartridge in position inside the printer.
<IMPORTANT>
W12 and W34 cartridges should correctly be placed at their original locations. Wrongly placed cartridges could cause a
printer malfunction.
(34) Repeat the same process to replace the other capping cartridge with the white ink pouch.
(35)
On the operation panel, press
.
Then, the white ink will be installed after the head is replaced with a new one.
<TIPS>
After the procedures are completed, the current screen will go back to the standby mode screen.
(36) Adjust the carriage speed.☞ "7-4-1. CR (Carriage) speed adjustment >>P.216"
(37) Print the nozzle check patterns. ☞ "7-2-1. Print out of the nozzle check pattern (checking on the print heads)
>>P.199"
(38) Perform the initial settings after head replacement configuration.☞ "7-4-2. Initial settings after head replacement
>>P.217"
(39) Adjust the ejection timing of the print head. ☞"7-4-3. Firing adjustment >>P.218".
(40) Perform the platen feed adjustment.☞ "7-4-4. Platen-rolling adjustment >>P.219".
(41) Make the position adjustment between the white head and the color head.☞ "7-4-5. White/color alignment
>>P.220"
To Next Page
Loading...
