Brother GTX pro - Page 299

299
Troubleshooting
(9) Remove the resin cover which is placed on the top of the carriage board and remove the flat cable.
X040
9
(10) Unlock the print head, and remove the print head.
<IMPORTANT>
 When removing the print head, be careful not to drip the ink on the carriage plate. If the ink is dripping, wipe off the dripping
ink.
②
①
X041
0
(11) Release the lock by pulling (a) part toward yourself, and take out the new print head from its case.
<IMPORTANT>
 When removing the print head, be careful not to touch the nozzle surface at the bottom of the head. Otherwise it may cause
poor printing.
<TIPS>
 Sometimes, you may find it hard to remove the print head when you try to open the lock of (a) part. If it is hard, use both
hands to remove it.
X006
9
Case
Print head
(a) part
Lock
Print head
Resin cover
Flat cable