Brother GTX pro - Page 47

47
Installation and preparation
(6) Adjust the carriage speed. Then adjust the printer using "GTX pro Maintenance".
Menu name Things to prepare See the operating procedure with
GTX pro Maintenance
1 [CR Speed Adjustment] ―
"7-4-1. CR (Carriage) speed
adjustment >>P.216"
2
[Initial settings after head
replacement]
―
"7-4-2. Initial settings after head
replacement >>P.217"
3 [Firing Adjustment]
Black paper or transparent sheet
(such as OHP sheet)
White paper
"7-4-3. Firing adjustment >>P.218"
4
[Platen-Rolling Adjustment]
White paper
"7-4-4. Platen-rolling adjustment
>>P.219"
5 [White/Color Alignment]
Black paper or pretreated black or
dark color T-shirt
"7-4-5. White/color alignment
>>P.220"
What to do in the White Ink Pause Mode
For the White ink pause mode, perform the following steps using the maintenance tool.
Menu name When in White Ink Pause Mode
1 [CR Speed Adjustment] Performed
2 [Initial settings after head replacement]
Performed for color head only
Upon completion of color head
setting, click [Cancel] to close the
maintenance tool once and then start
it. Then proceed to the following
steps.
3 [Firing Adjustment]
Performed for color head only
Upon completion of color head
setting, click [Cancel] to close the
maintenance tool once and then start
it. Then proceed to the following
steps.
4 [Platen-rolling adjustment] Performed
5 [White/Color Alignment] Not required
6 [Setting of the time displayed on the nozzle check pattern] Performed