Brother HL-5450DN - Page 69

2-33
Confidential
 Error code 5500
Printable pages set for the laser unit have reached the limit. (Printing does not stop.)
 Error code 5600
The eject sensor detected that the fuser cover was open.
Replace Laser
Step Cause Remedy
1 End of life of the laser unit Replace the laser unit.
2 Main PCB failure Replace the main PCB ASSY.
Cover is Open
<User Check>
• Close the fuser cover.
Step Cause Remedy
1
Eject actuator attachment
failure
Reattach the eject actuator.
2
Eject actuator spring
attachment failure
Reattach the eject actuator spring.
3
Eject actuator and/or fuser
cover failure
Replace the fuser cover.
4
Eject sensor PCB failure Refer to "1.3.8 Check sensor operation
(function code: 32)" in Chapter 5 to check the
sensor operation. If the sensor operation is
faulty, replace the eject sensor PCB ASSY.
5 Main PCB failure Replace the main PCB ASSY.