Brother MFC-9010CN - Step by Step Chart for Wireless Network Configuration; For Infrastructure Mode

Configuring your machine for a wireless network (For MFC-9320CW)
25
3
Step by step chart for wireless network configuration 3
For Infrastructure mode 3
a Confirm your network environment. See page 27.
b Confirm your wireless network setup method. See page 28.
c Configure your machine for a wireless network. See page 31.
Wireless configuration and installing drivers and software have been completed.
 Infrastructure mode
Connected to a computer with an access point
or
 Ad-hoc mode See page 26
Connected to a wireless capable computer without
an access point
Using the Brother
installer application
(Recommended)
Using the
SES/WPS/AOSS
control panel menu
(Automatic
Wireless mode)
Using the Setup
Wizard from the
control panel
Using the PIN
Method of Wi-Fi
Protected Setup
(Windows
®
)
Temporarily using a
USB cable
(Macintosh)
Temporarily using a
network cable
See page 40 See page 42 See page 31 See page 34 See page 38
Installing drivers and software (See the Quick Setup Guide)