Brother MFC-9010CN User Manual

Configuring your machine for a wireless network (For MFC-9320CW)
29
3
Ethernet cable method (For Macintosh)
 If there is an Ethernet Hub or Router on the same network as the WLAN access point (A), you can
temporarily connect the Hub or Router to the machine using a network cable (B). You can then remotely
configure the machine from a computer on the network.
Configuration using the SES/WPS or AOSS control panel menu
(Automatic Wireless mode) (Infrastructure mode only) 3
If your wireless access point (A) supports either SecureEasySetup, Wi-Fi Protected Setup (PBC
1
) or
AOSS™, you can configure the machine without knowing your wireless network settings. (See Using the
SES/WPS or AOSS control panel menu to configure your machine for a wireless network (Automatic Wireless
mode) on page 31.)
1
Push Button Configuration
Configuration using the machine’s control panel Setup Wizard to configure
your machine for a wireless network 3
You can use the machine’s control panel to configure your wireless network settings. By using the control
panel Setup Wizard function, you can easily connect your Brother machine to your wireless network. You
must know your wireless network settings before you proceed with this installation. (See Using the
Setup Wizard from the control panel on page 34.)
B
A
A

Brother MFC-9010CN Specifications

General

Brand	Brother
Model	MFC-9010CN
Category	All in One Printer
Language	English