Control panel setup
60
6
Ethernet (wired network only) 6
Ethernet link mode. Auto allows the print server to operate in 100BASE-TX full or half duplex, or in 10BASE-T
full or half duplex mode by auto negotiation.
You can fix the server link mode to 100BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and
10BASE-T Full Duplex (10B-FD) or Half Duplex (10B-HD). This change is valid after the print server has been
reset (default is Auto).
If you incorrectly set this value, you may not be able to communicate with your print server.
a Press Menu.
b Press a or b to choose Network.
Press OK.
c (MFC-9320CW only)
Press a or b to choose Wired LAN.
Press OK.
d Press a or b to choose Ethernet.
Press OK.
e Press a or b to choose Auto, 100B-FD, 100B-HD, 10B-FD or 10B-HD.
Press OK.
f Press Stop/Exit.
Setup Wizard (MFC-9320CW wireless network only) 6
The Setup Wizard guides you through the wireless network configuration. (For more information, see the
Quick Setup Guide or Using the Setup Wizard from the control panel on page 34.)
SES/WPS/AOSS (MFC-9320CW wireless network only) 6
If your wireless access point supports either SecureEasySetup, Wi-Fi Protected Setup (PBC
1
) or AOSS™
(one-push method), you can configure the machine easily without a computer. Your Brother machine has the
SES/WPS/AOSS menu on the control panel. This feature automatically detects which mode your access
point uses, SecureEasySetup, Wi-Fi Protected Setup or AOSS™. By pushing a button on the wireless access
point/router and the machine, you can setup the wireless network and security settings. See the user’s guide
for your wireless access point/router for instructions on how to access one-push mode. (For more information,
see the Quick Setup Guide or Using the SES/WPS or AOSS control panel menu to configure your machine
for a wireless network (Automatic Wireless mode) on page 31.)
1
Push Button Configuration
To Next Page
Loading...
Need help?
General
