Brother MFC-9010CN - Set to Default (MFC-9320 CW Only); Wired Enable (MFC-9320 CW Wired Network Only)

Control panel setup
63
6
Set to Default (MFC-9320CW only) 6
The Set to Default allows you to reset each wired or wireless settings to the factory default. If you want
to reset both wired and wireless settings, see Restoring the network settings to factory default on page 79.
a Press Menu.
b Press a or b to choose Network.
Press OK.
c (For Wired) Press a or b to choose Wired LAN.
(For Wireless) Press a or b to choose WLAN.
Press OK.
d Press a or b to choose Set to Default.
Press OK.
e Press 1 to choose Reset.
f Press Stop/Exit.
Wired Enable (MFC-9320CW wired network only) 6
If you want to use the wired network connection, set Wired Enable to On.
a Press Menu.
b Press a or b to choose Network.
Press OK.
c Press a or b to choose Wired LAN.
Press OK.
d Press a or b to choose Wired Enable.
Press OK.
e Press a or b to choose On or Off.
Press OK.
f Press Stop/Exit.