Brother MFC-9010CN - Configuring the Standard TCP;IP Port; Printer Driver Not yet Installed; Printer Driver Already Installed

Network printing from Windows
®
: basic TCP/IP Peer-to-Peer printing
88
8
Configuring the standard TCP/IP port 8
Printer driver not yet installed 8
a Put the supplied CD-ROM into your CD-ROM drive. If the model name screen appears, choose your
machine. If the language screen appears, choose your language.
b The CD-ROM main menu will appear. Click Initial Installation.
c Click Printer Driver Only (for Network).
d Click Next in response to the Welcome message. Follow the on-screen instructions.
e Choose Standard Installation and click Next.
f Choose Brother Peer-to-Peer Network Printer, and then click Next.
g Follow the on-screen instruction, and then click Next.
Note
Contact your administrator if you are not sure about the location and name of the printer on the network.
h Continue through the wizard clicking Finish when complete.
Printer driver already installed 8
If you have already installed the printer driver and wish to configure it for network printing, follow these steps:
a (Windows Vista
®
)
Click the button, Control Panel, Hardware and Sound, and then Printers.
(Windows
®
7)
Click the button, Devices and Printers.
(Windows Server
®
2008)
Click the Start button, Control Panel, Hardware and Sound, and then Printers.
(Windows
®
XP and Windows Server
®
2003)
Click the Start button and choose Printers and Faxes.
(Windows
®
2000)
Click the Start button and choose Settings and then Printers.
b Right click on the printer driver you wish to configure, and then choose Properties.
c Click the Ports tab and click Add Port.
d Choose the port that you wish to use. Typically this would be Standard TCP/IP Port. Then click the
New Port... button.
e The Standard TCP/IP Port Wizard will start.
f Enter the IP address of your network printer. Click Next.