Configuring your machine for a wireless network (For MFC-9320CW)
33
3
(Windows
®
)
You have completed the wireless network setup. If you would like to continue installing drivers
and software necessary for operating your device, please choose Install MFL-Pro Suite from
the CD-ROM menu.
(Macintosh)
You have completed the wireless network setup. If you would like to continue installing drivers
and software necessary for operating your device, please double-click Start Here OSX from
the CD-ROM.
LCD messages when using the SES/WPS/AOSS control panel menu
LCD shows Connection status Action
Setting WLAN
Searching or accessing the access
point, and downloading settings from the
access point.
—
Connecting SES
Connecting WPS
Connecting AOSS
Connecting to the access point. —
Connected Connection succeeded. —
Connection Error Session overlap has been detected.
Check that only one router or access point has
the SecureEasySetup mode, the Wi-Fi Protected
Setup mode or AOSS™ mode enabled and try
starting from step c again.
No Access Point The access point detection failed.
Move the machine closer to your access
point/router and try starting from step c again.
Connection Fail Connection failed.
1 Try starting from step c again.
2 If the same message continues, reset the
machine back to the factory settings and try
again.
To Next Page
Loading...
Need help?
General
