Wireless configuration for Macintosh using the Brother installer application (MFC-9320CW only)
46
5
h Connect the Brother wireless device to your access point using a network cable and click Next.
i Choose the machine you wish to configure, and click Next. If the list is blank, check if the access point
and the printer are powered on, and then click Refresh.
• The default Node name is “BRNxxxxxxxxxxxx”. (“xxxxxxxxxxxx” is your machine’s MAC Address /
Ethernet Address.)
• You can find your machine’s MAC Address / Ethernet Address by printing out the Network Configuration
List. See Printing the Network Configuration List on page 80.
To Next Page
Loading...
Need help?
General
