Brother MFC-9010CN - Page 67

Control panel setup
56
6
e Press a or b to choose Node Name.
Press OK.
f Press 1 to choose Change.
g Enter the Node Name using the dial pad. (To enter numbers and text, see Entering Text on page 189.)
Press OK.
h Press Stop/Exit.
WINS Config 6
This selection controls how the machine obtains the IP address of the WINS server.
a Press Menu.
b Press a or b to choose Network.
Press OK.
(MFC-9120CN, MFC-9010CN and DCP-9010CN) Go to step d.
(MFC-9320CW) Go to step c.
c (MFC-9320CW only)
(For Wired) Press a or b to choose Wired LAN.
(For Wireless) Press a or b to choose WLAN.
Press OK.
d Press a or b to choose TCP/IP.
Press OK.
e Press a or b to choose WINS Config.
Press OK.
f Press a or b to choose Auto or Static.
Press OK.
g Press Stop/Exit.
Auto
6
Automatically uses a DHCP request to determine the IP addresses for the primary and secondary WINS
servers. You must set the BOOT Method to Auto for this feature to work.
Static
6
Uses a specified IP address for the primary and secondary WINS servers.